The Ultimate Guide to Cleaning Your Taylor Ice Cream Machine

Ensure your Taylor soft serve machine is always ready to deliver the creamy, delicious ice cream your customers crave. Neglecting proper cleaning and reassembly can result in:

  • Unwanted bacteria infiltrating your product
  • Costly equipment malfunctions from worn or misplaced components

Our comprehensive guide offers step-by-step cleaning instructions specifically designed for the Taylor C712 soft serve freezer, yet versatile enough for most Taylor models.

Step 1: Drain Your Machine

  1. Switch the machine from the freeze mode to wash.
  2. Activate the pump button then fully open the draw valves to drain all the product.
  3. Carefully remove the pin from the feed tube and extract it gently after the hopper is empty.
  4. Finish draining the mix and turn off wash and pump modes.

Step 2: Cleaning the Machine

  1. Gather these a bucket, Taylor approved brushes, sanitizer (Stera Sheen), lubricant, Taylor parts (tune-up kits, seals, O-rings
  2. Gradually pour 2 gallons of water into the hopper.
  3. Detach the pump and feed tube, placing them in the bucket.
  4. Switch to wash mode and thoroughly scrub the hopper.
  5. Repeat the process until the water is crystal clear.

Step 3: Disassembly

Disassembly is essential for a thorough cleaning.

  1. Utilize the pump removal tool to disconnect the pump drive shaft.
  2. Detach the door by unscrewing handles, draw valves, and screws.
  3. Remove the beater assembly, including blades and shoes.
  4. Disassemble smaller components: O-rings, bushings, bleeder valves, and draw valves.
  5. Put all parts in a cleaning bucket.

Step 4: Part Cleaning for Longevity

  1. Fill a sink with warm, soapy water.
  2. Use an O-ring removal tool, avoiding sharp objects, and replace any damaged O-rings.
  3. Clean the pump, door, smaller parts, and beater assembly with appropriate brushes.
  4. Rinse thoroughly and air dry all components.

Step 5: Reassembly

  1. Pump Assembly: Apply lubricant to O-rings and securely reassemble the pump.
  2. Feed Tube and Barrels: Assemble the feed tube with gaskets and O-rings. Insert and secure the drive shaft into the barrel, applying lubricant as needed.
  3. Door and Beater Assembly: Attach the door, ensuring all lubricated O-rings and gaskets are correctly seated. Secure the draw valves and handles.

Step 6: Sanitizing

Maintain your machine’s hygiene with these sanitizing steps.

  1. Mix Stera Sheen sanitizer with cool water.
  2. Pour sanitizer into the hopper and run a wash cycle.
  3. Soak the feed tube and allow the sanitizer to circulate through the pump and machine parts.
  4. Drain all sanitizer water completely.